Comdial DX-80 - Page 281

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-231
• Select Programming from the PC-DBA menu. Then press
«.
Program Digit Interval(s) and assign Extension/CO Line COS to Digit Intervals:
• Use
¢£¤¥ to highlight “Restriction” and then press «.
• Use
¢£¤¥ to highlight “Toll Restriction” and then press «.
• Use ¢£¤¥ and ³´ to highlight the “FROM” or “TO” column of the Digit Interval.
• Press
«.
• Input the digit(s) to be monitored. (E.g., to restrict long distance and operator calls, input “2” in the From
column and input “#” in the To column. Thereby eliminating “0” and “1” as possible first dialed digits.)
• Use ¢£¤¥ and ³´ to highlight the “Extension” or “CO Line” COS under the service mode “Day” or
“Eve” for the Interval.
• Press
« to select “Y” or “N” for this COS/Mode/Interval.
• When all changes are made press the
° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
Program Extensions for the COS to follow:
• Use
¢£¤¥ to highlight “Extension” and then press «.
• Use
¢£¤¥ to highlight “Category 1” and then press «.
• Use ¢£¤¥ and ³´ to highlight the COS Day or Eve of the extension for which changes are to be
made.
• Press
« until the appropriate COS assignment displays.
• Continue making other programming changes as required.
• When all changes are made press the
° (escape) key to exit this database-programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
Program CO Lines for the COS to follow:
• Use ¢£¤¥ to highlight “CO Line” and then press «.
• Use
¢£¤¥ to highlight “Category 2” and then press «.