DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-264
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
Program Warning Time Incoming/Outgoing
• Use
¢£¤¥ to highlight “Call Handling.” Then press «.
• Use
¢£¤¥ to highlight “Call Handling.” Then press «.
• Use ¢£¤¥ to highlight Warning Time – Outgoing Call or Warning Time – Incoming Call. Then press
«.
• Input the time for calls of this type.
• Press
«.
• Continue making other programming changes as required.
• When all changes are made press the ° (escape) key to exit this database-programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.
To Next Page
Loading...
