Wiring
3
Important notes:
♦ Power supply must be turned off
during mounting and wiring!
♦ In case of 90...250 VAC/DC power supply,
grounding the device via separate wire
is mandatory for covering safety standards.
♦ With DC power supply,
the polarity does not matter.
Input signal wiring
Connect the input
with regard to its type
through the respective and
depending on the case type
(see 'Specifications')
terminals on the device back.
Voltage transmitters
should be powered
ONLY
by external source!
Output wiring
Connect the output
with regard to its type
(see 'Specifications')
via the respective terminals.
Power supply wiring
Connect the right power
supply voltage for your device
(see 'Specifications')
through the respective
terminals.
More detailed
wiring schematics
are available at
comecogroup.com
under 'Support' tab.
To Next Page
Loading...
