9
General setup
Choose the "General setup" and turn into it's setup interface.
Time
：
the real time when preview, click” refresh” after setting, make sure saving when it shows” the
recording will stop once you modify the time” and save the setting.
Auto Logout: the present user will be logged off if there is no operation within 10 minutes, and it
needs login again.
Key Buzzer
：
enabled, there is sound with the controller or pressing key on front panel. Disabled,
without sound.
Language
：
there is multiple choices according to users, English and so on.
Remote ID
：
user can use this ID to control the NVR by remote controller. The remote controller
should be correspond with the ID so that it can work.
Device mode: user can choose from various video format (1080p and so on)
After setting finished, click "ok", the information will be saved. Click "cancel" to exit without saving.
Channel Setup
Before connecting and set up IPC, please confirm that IPC is already connected to LAN.
Right click on the preview interface, pop-up shortcut interface, click “IPC Add" and after "Auto Add".
Delete channel: delete the selected connected IPC.
View channel: check connection status between NVR and IPC.
Edit channel: modify the IPC parameters of the selected IPC
After finish setup, click “ Ok” button, it will be saved; click: “Cancel” button, it will be not save.
To Next Page
Loading...
