39
• Selective group intercom
This is an intercom call to groups of several door entry monitors in the same apartment or another
apartment identified by a dedicated intercom code, dierent from the user code. The door entry monitor
button can be programmed with up to 3 dierent intercom codes to which the call will be made at once.
The maximum number of door entry monitors which can ring simultaneously nevertheless remains 3.
1. Program the intercom code on the door entry monitors you want to call.
2. On the desired button, program the “selective group intercom” function for the intercom codes of the
door entry monitors you want to call.
NOTE:
intercom and selective intercom CANNOT be programmed in the same system!
FUNCTIONS ASSOCIATED WITH THE CFP INPUT
In addition to the floor door call, other functions can be associated with the CFP input (CFP and CFP
terminals):
• Control of a generic actuator or with a code.
• Remote control of lock-release command.
CALL RANGE
The door entry monitor can be programmed to receive calls originating from the outdoor entrance panel and
direct calls, to both your own user code and an interval (range) of user codes.
Example:
If the door entry monitor is programmed with user code “1” and the range of user codes from 5 to 7 is also
programmed, when the function is enabled it will receive both direct calls to user code “1” and direct calls to
user codes 5, 6 and 7.
√ The user can only activate/deactivate the range of user codes if they have been
authorised to do so by the installer, via the MyComelit app.
Range activation:
f Press and hold buttons
and together for 5 seconds.
» The text “ON” appears on the door entry monitor display for 3 seconds.
» The
LED flashes to indicate that the function is active.
Range deactivation:
f Press and hold buttons
and together for 5 seconds.
» The text “OFF” appears on the door entry monitor display for 3 seconds.
» The
LED switches off.
To Next Page
Loading...
