Need help?Do you have a question about the Comelit Simplebus2 Ultra UT2020 and is the answer not in the manual?
General| Brand | Comelit |
|---|---|
| Model | Simplebus2 Ultra UT2020 |
| Category | Control Unit |
| Language | English |
Details product's intended application and safety requirements for installation personnel.
Provides guidelines for safe wiring practices and avoiding interference with power cables.
Outlines safe product operation and maintenance procedures, including approved repair methods.
States manufacturer's responsibility regarding product use, modifications, and information updates.
Describes the UT2020 as an audio/video module for Ultra entrance panels with specific features.
Details the UT2010VC as an audio module for connecting an analogue remote camera.
Provides recommended installation height and viewing angle considerations for optimal camera performance.
Lists detailed technical parameters for the UT2020 module, including electrical and hardware characteristics.
Details the technical specifications for the UT2010VC module, covering general, audio, and electrical aspects.
Step-by-step instructions for installing the entrance panel flush-mounted in a wall.
Instructions on how to safely remove nameplates and modules from the entrance panel.
Guidance for installing multiple entrance panel boxes side-by-side.
Step-by-step instructions for installing the entrance panel surface-mounted on a wall.
Illustrates basic wiring for UT2020 and UT2010VC modules with standard power supply units.
Shows how to connect modules when using an external power supply unit.
Details connection setups for different system configurations, including relay and door lock options.
Specific wiring instructions for connecting a remote camera to the UT2010VC module.
Explains module power draw and requirements for supplementary power supplies.
Wiring diagram for connecting UT9200 call button modules to the system.
Wiring guide for integrating UT9270 touch-screen modules into the system.
Instructions for wiring UT9279M numeric keypad modules.
How to set buttons as single-function or dual-function using DIP switches.
Method for assigning unique addresses to button modules for system recognition.
Instructions on assigning specific call addresses to buttons for apartment selection.
Efficiently program multiple buttons with sequential apartment addresses using DIP switches.
Guide for assigning unique, non-sequential addresses to specific buttons.
Utilizes DIP switches for custom system functions and settings beyond basic addressing.
How the twilight sensor controls camera and button LED lighting modes (ON, OFF, AUTO).
Procedure to test the functionality of the twilight sensor in AUTO mode.
Instructions for modifying the brightness levels of button LEDs and the camera light.
Describes how the Light-Me button interacts with LED backlighting modes for energy saving.
Procedure for replacing an audio/video module while retaining existing programming settings.
Information on using PC software for device configuration and management.
Lists common error indicators (LEDs, tones) and their corresponding troubleshooting solutions.
Guidance on finding information regarding system performance and installation layouts.
To Next Page
