INSTRUCTIONS FOR THE USER
48
4)SANITIZING THE MACHINE
Sanitizing the machine at least once a week is of the utmost importance in
order to guarantee hygiene even when the machine is not in use.
It is advisable to use a disinfecting product suggested by an authorised
detergent dealer.
The use of this product will satisfy hygienic requirements, even during
machine non use.
Before switching off the machine run the machine briefly with clean
water.
5)HARD WATER CONDITIONS
If a hard water supply is present, mineral deposits will form within the machine
and also on dishware.
In order to avoid the above conditions a periodic removal of these deposits is
necessary.
The frequency and method of this operation upon consultation by your
detergent supplier.
6)RESINS REGENERATION OF THE WATER SOFTENER (only for machines with
built-in water softener)
The regeneration of the water softener resins is completely automatic.
The presence of some opaque spots on the glasses will show that it is
necessary to start the regeneration.
First of all, make sure that in the designated tank container "S" there is some
regeneration salt (1kg is enough for about 5 regenerations).
This operation has to be carried out with full tank.
Machine on, close the front door and press the button "S4" for approx.
3sec.
After that the lamp "H3" flashes for 20 minutes (during this operation the
machine cannot be used).
The end of which will be indicated by the switching off of the "H3" lamp.
Turn off the machine, take out the overflow pipe from the tank and wait until it
is completely empty then close the door, turn on the machine for a few
minutes to wash the machine.
At this point switch off the machine, replace the overflow in its place, the
equipment is ready to be used.
To Next Page
Loading...
Need help?
General
