Comet KT 1900 extra - Safety Devices; Amperometric Protection; Thermic Protection; Pressure Restriction;Adjustment Valve

13
EN
19 Detergent Cap
20 Inlet Water Filter
21 Hose Reel Knob
EXTRA
22 Fixed Brush EXTRA
23 High pressure hose
24 Wheel
25 Safety catch on water gun lever
26 Water gun lever
27 Machine Foot
28 High pressure hose Support
CLASSIC
29 Outlet Coupling CLASSIC
30 Quick fit connector for high-pressure hose
CLASSIC
SAFETY DEVICES
• Amperometric protection (KT 1800 - KT 1900)
This device stops the high-pressure water cleaner in the event of electrical overcurrent, in that condition
the master switch (2) goes in position “0”.
Carry out the following if activated:
- disconnect the plug from the wall socket:
- press lever (26) of the gun to discharge possible residual pressure;
- wait 10-15 minutes to allow the high-pressure cleaner to cool; check that the requirement for the mains
power connections have been respected (see the
INSTRUCTION MANUAL  SAFETY WARNINGS ),
paying particular attention to the extension lead used;
- Reconnect the plug and repeat the start procedure described at paragraph
“OPERATION” .
• Thermic protection (KT 1750)
This device stops the high-pressure water cleaner in the event of electrical overcurrent.
Carry out the following if activated:
- place the master switch (2) in position “0” and disconnect the plug from the wall socket;
- press lever (26) of the gun to discharge possible residual pressure;
- wait 10-15 minutes to allow the high-pressure cleaner to cool; check that the requirement for the mains
power connections have been respected (see the
INSTRUCTION MANUAL  SAFETY WARNINGS ),
paying particular attention to the extension lead used;
- Reconnect the plug and repeat the start procedure described at paragraph
“OPERATION” .
• Pressure restriction/adjustment valve.
This valve that is set by the Manufacturer allows the pumped liquid to return to the pump suction, preventing
the development of hazardous pressures when the gun is closed or when a pressure value is set over the
maximum allowed.
• Gun lever blocking device.
This safety catch (25) allows to block the lever (26) of the gun (14) in the closed position, preventing accidental
activation
PICT. 8, POSITION S .
STANDARD EQUIPMENT
Make sure that the following parts are included in the packaging of the purchased product:
• high-pressure cleaner;
• high-pressure delivery hose 8 m/26 ft
CLASSIC ;
• hose reel complete with 12 m/39 of high-pressure delivery hose
EXTRA ;
• watergun;
• lance pipe;
• rotating lance
EXTRA ;
• xed brush
EXTRA ;
• hose reel knob;
• handlebar;
• foot;
• 4 screws for assembling braket and handlebar;
• 2 wheel;
• instruction manual - safety warnings;
• instruction manual - use and maintennace;
• warranty certicate;
IDENTIFICATION OF COMPONENTS (continues)