Comfee CDC17P0ABB - Turning On The Appliance; Change The Program

Turning On The Appliance
Starting a wash cycle...
Draw out the basket(see the section entitled "Loading the Dishwasher").
Pour in the detergent (see the sectionFill the detergent).
Insert the plug into the socket. The power supply is 120VAC 60HZ,
Press the power button to turn on the appliance,
Connect the inlet hose to the tap, make sure that the water supply is turned on
to full pressure, or add water to the tank manually.
Select a suitable program according to the Wash cycle table;
If a program is selected, the response light will illuminate. Then press the Start/
Cancel button, the dishwasher begins to start.
-19
-
NOTE
When you press the Start button to pause during washing, the dishwasher
will mooing every minute unless you press the Start button to start.
Change The Program
A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have
already drained the wash water. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1. Press and hold Start button for more than 3 seconds,the machine will be in
stand by state.
2.
3. Press the Start button.
Press CYCLES button to select the desired program.
HYGINENE C2 GLASS C3 FRUIT