WARN!NG!
!t is dangerous to open the door when washing because the hot water may scald you
When the working cycle has finished the buzzer of dishwasher will sound for 8 seconds then stop Turn off
the appliance using the ON/OFF button shut off the water supply and open the door of the dishwasher
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage They will also dry better
Since the appliance is standing by it will power off automatically after 30 minutes without any operation
Switch Off the Dishwasher
All the phase lights are off only in this case the program has ended
1 Switch off the dishwasher by pressing the ON/OFF button
2 Turn off the water tap!
Open the door carefully
Hot dishes are sensitive to cold shock The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance
Open the dishwasher's door leave it ajar and wait a few minutes before removing the dishes !n this way they
will be cooler and the drying will be improved
Unloading the dishwasher
!t is normal that the dishwasher is wet inside
Change the Programs
Forgot to Add a Dish?
At the End of the Wash Cycle
A forgotten dish can be added any time before the detergent cup opens
completely
3
After the spray arms stop working you can open the door
Add forgotten dishes
5
Close the door
1 Press the start/pause button
2 Open the door a little to stop the washing
6
Press the start/pause button the dishwasher will run
after 10 seconds
!f youopen thedoor whenwashing themachinewill pause Whenyouclosethedoor
youneed pressstart/pausebuttonto continuethecycle
NOTE:
Premise: You can modify the washing program at the beginning of the cycle Otherwise the detergent may have
already been released and the appliance may have already drained the wash water !f this
is the case the detergent dispenser must be refilled (see the section entitled
" Loading the Detergent " )
To change the washing program press the Start/pause button to pause the machine then press
the program button more than three seconds to set the machine into standby then you can
change the program to the desired cycle setting
(See the section entitled " Starting a wash cycle " )
The lights show the state of the dishwasher:
a) All phase lights off----------------------------------Stand by
b) The display no blinking ---------------------------Paused
c) The display blinking -------------------------------Running
10
To Next Page
Loading...
Need help?
General
