How to Keep Your Dishwasher in Shape
When it is not in need for a long time
!t is recommend that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket turn off the water supply and leave the door of
the appliance slightly open This will help the door
seals to ast longer and prevent odours from forming
within the appliance
Moving the Appliance
!f the appliance must be moved try to keep it in the
vertical position !f absolutely necessary it can be
positioned on its back
Seals
One of the factors that cause odors to form in the
dishwasher is food that remains trapped in the seals
Periodic cleaning with a damp sponge will prevent this
from occurring
7 !nstallation !nstructions
After Every Wash
After every wash turn off the water supply to the
appliance and leave the door slightly open so that
moisture and odors are not trapped inside
Remove the Plug
Before cleaning or performing maintenance always
remove the plug from the socket
No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the dishwasher
do not use solvents or abrasive cleaning products
Only use a cloth with warm soapy water
To remove spots or stains from the surface of the
interior use a cloth dampened with water with a little
vinegar or a cleaning product made specifically for
dishwashers
The installation position of dishwasher should be near the existing inlet and drain
hoses and power cord
One side of the cabinet sink should be chosen to facilitate the connection of drain
hoses of the dishwasher
!nstallation Preparation
Cleaning the Spray Arms
The spray arms can be easily removed for periodic cleaning
of the nozzles to prevent possible clogging Wash them
under running water and carefully replace them in their seats
checking that their rotary movement is in no way impeded
Grasp the middle of the spray arm pull it upwards to remove
it Wash the arms under a jet of running water and return them
carefully to their seat After reassembly check that the spray
arms turn freely Otherwise check that they have been
installed correctly
13