4
OPERATION INSTRUCTIONS
Power ( )
Press button to begin boiling, or after selecting a custom temperature to begin heating.
Temperature ( )
Allows you to set the desired temperature for heating or Keep Warm from105°F-205°F
Keep Warm ( )
Allows you to enable or to disable the Keep Warm mode.
CONTROLS/FUNCTIONS
1. Read all instructions and important safeguards.
2. Remove all packing materials and make sure that the product has been received in
good condition.
3. Wipe out the interior of the kettle with a damp cloth. If your hand will not fit inside the
kettle, swish warm, soapy water around in the interior of the kettle with the lid closed.
4. Rinse out the inside of the kettle thoroughly with water.
5. With a damp cloth, gently wipe o the exterior of the kettle. Do not wipe o electrical
components as this may cause damage to the unit.
6. Dry all parts completely.
7. It is recommended to run your kettle through one boiling cycle before first use.
Following the instructions in “Heating Water” on page 7, boil one kettle of water. When
water has boiled, pour it out and rinse the inside of the kettle once more. The kettle is
now ready for use.
BEFORE FIRST USE
HEATING WATER
1. Place power base on a sturdy, level, and dry surface.
2. Make sure that the removable filter is properly inserted. See “Removing/Inserting the
Filter” on page 9 for instructions on inserting the filter.
3. Open the lid and fill with water. Water must be filled between the Min and Max levels
inside the kettle.
4. Close the lid securely. The lid will make a light “click” sound when it locks into place.
5. Plug the power cord into a wall outlet and place the kettle onto the power base. The
kettle will beep once and the indicator lights will flash.
6. Press ( ) to start boiling (212°F), or ( ) to select a custom temperature followed
by ( ) to begin heating. When using ( ) to select a custom temperature, the
temperature will increase by 10 degrees up to 205°F with each button press.
To Next Page
Loading...
