Installation and Usage
Pairing Method(All have been paired by default. If you need to re-pair,
please follow the instructions
)
Place the transmitters and receiver within one meter and long press their
power buttons to switch on, then long press their pair buttons to enter the
pairing state. During the pairing state, the indicator lights of transmitters
alternately flash red, blue, and green, and the receiver screen shows" Pair....".
After successful pairing, the indicator lights of the transmitters turn blue, and
the receiver screen displays the status of the connected channels.
If any transmitter is not paired, please turn off all transmitters and receiver,
and then follow the above steps to pair again.
Stereo
A
VOL 4
B
VOL 4
C
VOL 4
D
VOL 4
9
To Next Page
Loading...
