1. Attach the wire guides to the inside of the baserail.
2. Route wires along the inside of the baserail using the wire guides.
**HOOK UP TO POWER & TEST MOTOR BEFORE MOVING ON TO STEP 5.**
19.
Connect MM4 Cable. Attach the strain relief and secure MM4 cable with a zip tie.
20.
STEP 3 - Reassemble Exit Device
1.
2.
Once guides & bumpers are installed on activating brackets slide on
the push pad.
Back of device
Front
Re-install pins and connecting rods on both
activating brackets
Rod
Connecting Rod
US customer support 1-888-622-2377 | www.commandaccess.com | CA customer support 1-855-823-3002
To Next Page
Loading...
