Commax CDL-100WL - Factory Reset Mode; Self-checking List

Self-checking list
You can see the status of the door lock by checking the flashing number
on the number plate.
Operation Self-Checking List
LED 1 ON FLASH
LED 2 ON FLASH
- Error on access code, fingerprint RF card registreation / delete (duplicate registration)
- Not registered password, fingerprint, RF card
LED 3 ON FLASH
Number of fingerprint/password registered
is full.
LED 4 ON FLASH Fire alarm
LED 5 ON FLASH Duplicate lock inside
LED 0 ON FLASH Trouble with fingerprint module
ALL NUMBERS ON FLASH Trouble with deadbolt
Factory Reset Mode
1. Press [Register] button
for 5 sec.
2. When all the lamp on
[number plate] is on, enter
“01234543210”.
3. Press [Start] button on outer handle for 2 sec.
0 1 2 3 4 5 *
Beep
Open the battery cover inside
of the main part and press
[Register] button for 5 sec.
Factory reset mode is on with the
confirmation tone when you press
[start] button for 2 sec.
1. All the setting goes default after the factory
reset mode.
Warning
Note
Settings for Factory Reset Mode
- password : [1][2][3][4]
- Sound setting : High
- Multi-layered authentication mode : Off
- Register authentication mode : Off
- 3D Touch mode : Off
- Direction of handle(left/right) : Right
Beep
None