7
4. Preparation
- For DC operation, operate the unit on 12V DC.
- Should any solid object or liquid fall into the cabinet, disconnected the unit and have it checked by
qualified personnel before operating it any further.
- The Connector will fit into the power outlet only one way. If you are unable to insert the connector
fully into the outlet, contact your dealer.
- Allow adequate air circulation to prevent internal heat build-up.
- Do not place the unit on surfaces (rugs, blankets,etc) or near materials(curtains, drapereis) that
may block the ventilation slots.
- Do not install the unit near heat sources such as radiators or air ducts or in a place subejct to
direct sunlight, excessive dust, mechanical vibration or shock.
- Keep the unit and glass away from equipment with strong magnets, such as a microwave oven or
large loudspeakers.
- When the unit is not in use, turn off the power to conserve energy and to extend its useful life.
- Clean the cabinet, glass and controls with a drt soft cloth, or a soft cloth lightly moistened with mild
detergent solution.
- Do not use any type of solvent, such as alcohol or benzene, which might damage the finish.
If you have any questions about this unit, contact your Commax dealer.
On Safety
On Installation
On Operating
On Cleaning
To Next Page
Loading...
Need help?
General
