Commodore 16 - Page 47

USING SOFTWARE
2. if there is a problem with the diskette or drive,
the red fight flashes on and off, even after the
disk stops spinning in the drive.
You can also use disks to store programs that you
write yourself.
Here are the steps to follow to load software from
disk:
1 Make sure that your disk drive is ON.
2 Insert the disk into the disk drive. The label
side of the disk must face up. Insert the
disk into the opening so the labeled end
goes in last. Look for a little notch on the
side of disk (it might be covered with a
sticker). This notch should be to your left as
you put in the disk, assuming that you're
facing your disk drive. Be sure the disk is in
all the way.
33