7900 Pager Programming Manual
Page 6 © CommtechWireless
3. THE 7900 PAGER
3.1 Case Layout
The Commtech 7900 pager has four buttons on its case.
| | | |
Escape Left Right Read
Key Key Key Key
3.2 Kit Components
Each programming kit contains:
The 7900 programming cradle with USB cable
A CDROM disk containing the 7900 programming software
This 7900 programming manual
3.3 Other Required Components
The following will also be required in order to program the pagers:
At least one 7900 pager that requires programming.
The cap codes that the pager will respond to.
The baud rate of POCSAG data that is being transmitted.
The frequency of the transmitter.
A start-up message that will be observed when turning on the pager.
An IBM compatible PC running Windows XP with a CDROM drive and a spare
USB port.
Basic IBM PC knowledge.
Basic understanding of POCSAG paging principles.
To Next Page
Loading...
