INS_CNGEMC4+2[POE][HO]/M 09/08/20 PAGE 24
INSTALLATION AND OPERATION MANUAL CNGEMC4+2[POE][HO]/M
TECH SUPPORT: 1.888.678.9427
PoE-PSE Status
Only applies to the CNGEMC4+2POE[HO].
Label Description
Port Power Displays the amount of power being used
Port Power Cycle Turns off PoE then enables to simulate a power cycle
Port PD Class Displays the PoE Class being used by the PoE device
Force PoE Enabled 60W of PoE (HO models only)
Warning: Please use Force PoE mode with caution and ensure it is only enabled when a 60W
PoE Device is attached. It should only be enabled if the 60W devices fail to power up
without this option enabled.
To Next Page
Loading...
