Compac C4000

Further Settings Available on the 'K' Factor Switch
Set-up Modes
Compac Industries Ltd.
Page 32
www.compac.co.nz
H-Cut
This is only available in Bulk Meter mode.
This value is the desired cut-off point to half flow (in litres) for the system.
The “H-Cut” sets the amount (in litres), prior to the preset amount being
attained, at which the flow rate of the system will be halved.
Setting H-Cut
Refer to K Factor Switch Settings (see page 21) While setting the “H-Cut”,
the price display shows 'HCUt' and the volume display shows 'HXXXX'.
F-Cut
This is only available in Bulk Meter mode.
This is the final cut-off point to pre-set (in litres) 'FXXX.X' for the system.
Setting F-Cut
Refer to K Factor Switch Settings (see page 21) While setting the “F-Cut”,
the price display shows 'FCut' and the volume display shows 'FXXXX'.