Need help?Do you have a question about the Compac C5000 and is the answer not in the manual?
General| Brand | Compac |
|---|---|
| Model | C5000 |
| Category | Control Unit |
| Language | English |
Manual title, publication date, and models covered.
Statement on product specification changes over time.
Company details and contact information for manufacturing.
File name and author of the document.
Record of document version changes and notes.
Essential safety advice before operating the equipment.
Specific safety guidelines for electrical components and operations.
Safety protocols related to the installation environment.
Measures to prevent damage from static discharge to electronics.
Details on the number and type of cable entry points.
Specifies the hazardous area classification and temperature range.
Recommendations for mounting the power supply unit.
Steps and requirements for physically installing the power supply.
Guidelines for correct electrical wiring practices.
Steps for initial power supply unit access.
Guidance on connecting the main power supply to the terminal board.
Diagram and table for setting up RS485/RS232 communication.
Illustrates typical wiring required for C5000 pumps.
Details on triac wiring, including color codes for service.
Shows wiring for C5000 electronics in dispenser applications.
Overview of available K-Factor settings and their display options.
Instructions on navigating and changing settings via the dispenser menus.
Guide to adjusting meter type, variant, and minimum delivery.
Setting options for different types of meters (encoder, V50).
Configuration for different product types like LPG or AdBlue.
Options for how dispensed quantity is displayed.
Configuration for air switch error triggering.
Definition and calculation of the minimum dispensable amount.
Procedure to match V50 meter ID with dispenser settings.
Adjusting temperature readings from the meter.
Adjusting density readings from the meter.
Setting the maximum flow rate for the pump.
Calibrating product flow by adjusting the K-Factor.
Configuring hardware variant, card totals, and pump mode.
Selecting different configurations for pump hardware and modes.
Setting up communication protocols and modes.
Adjusting the time between motor start and solenoid activation.
Setting the volume at which delivery slows for accuracy.
Configuring how dispensed amounts are rounded to the preset.
Setting the duration before a transaction times out after flow stops.
Overview of parameter switch settings for the dispenser.
Instructions on navigating and changing parameter settings.
Procedure to check the current software version.
Setting a unique number for each pump side.
Setting the price per litre for the product.
Configuring pump modes like authorisation or standalone.
Explanation of the standard display and operation mode.
Description of the test mode for calibrated runs.
Setting the minimum flow rate to avoid transaction errors.
Setting the maximum flow rate to prevent errors.
Configuration for LCD dimming.
Setting up secondary displays to mirror or show specific data.
Customizing the unit price display with additional information.
Displaying details of the most recent transaction.
Accessing recorded price and dollar totals.
Performing operational tests to ensure correct electrical function.
Procedures for mechanical setup and testing of the unit.
Explains the function and status of LEDs on the processor board.
Details the meaning of LEDs on the K-Factor board for diagnostics.
Table describing output LEDs for different operational modes.
Diagnosing and resolving power-related issues.
Identifying reasons for the pump stopping during operation.
Troubleshooting steps for a pump that fails to start.
Diagnosing issues when the pump fails to stop.
Steps to diagnose why solenoids are not activating.
Troubleshooting solenoids that fail to deactivate.
Diagnosing issues with flashing digits on the preset display.
Checking communication and connections for PIN pad issues.
Diagnosing mechanical faults and issues.
Identifying issues related to unit calibration.
Steps to check why a solenoid valve is not opening.
Advice on using generators and protecting the unit from power spikes.
Table explaining codes displayed upon transaction completion.
Comprehensive list of error codes, their faults, and corrective actions.
To Next Page
