Pump Settings
Each setting is a different configuration with different hardware.
See below for descriptions of these configurations.
For all pump settings, the main display shows information on
side A. Slave displays will need to be configured to show side
B.
Single Pump or Dispenser
In single mode, one outlet is used to dispense one product. The price per litre window for side B
is not used.
In this setting, only side A settings will appear in the menus.
Dual Pump or Dispenser
In Dual mode, the dispenser or pump has two outlets which can be used separately, at the same
time. Each outlet can be configured separately. Two separate products can be used. Side A
supports high flow.
Dual 160 Dispenser
In Dual 160 mode, the dispenser has two outlets, however they must dispense the same
product. Either outlet can support high flow and both outlets can be used simultaneously.
Dual 160 mode can only be used in dispenser application, and not for pump application.
Dual HLB Pump or Dispenser
In Dual HLB mode, the dispenser or pump has two outlets which can be used separately, at the
same time. Each outlet can be configured separately. Two separate products can be used. Side B
supports high flow.
Main display (K-
Factor display)
To Next Page
Loading...
Need help?
General
