Need help?Do you have a question about the Compac C4000 and is the answer not in the manual?
General| Brand | Compac |
|---|---|
| Model | C4000 |
| Category | Control Unit |
| Ethernet | 2 x Gigabit Ethernet |
| Weight | 1.2 kg |
| Memory | 4GB DDR3L |
| Storage | 64GB SSD |
| Operating System | Windows 10 IoT Enterprise |
| Display Outputs | VGA, HDMI |
| Power Supply | 12V DC |
Explains symbols used for warnings and notes in the manual.
Lists units used for pressure, temperature, volume, mass, length, etc.
Precautions for clean servicing areas and avoiding dust/dirt ingress.
Precautions for power disconnection and safe handling of wiring.
Details hazardous area certification and use of certified parts.
Guidelines for handling electronic components to prevent static discharge.
Specifies cable types, sizes, and counts for power and communication.
Details wiring power and comms to the termination board and earth connection.
Outlines the electrical operational test procedure for the C4000.
Lists and illustrates the primary components of the C4000 microprocessor board.
Details standard configurations for the C4000 head in various dispenser types.
Explains the 5-digit code used to configure pump/dispenser mode.
Details settings for auto-authorise, transaction data, and other operational modes.
Guides users through setting up the C4000 head using the K Factor switch.
Explains parameter switch functions for configuration and diagnostics.
Covers 230V wiring, communication wiring, and comms DIP switch configuration.
Details Gilbarco converter, intrinsically safe wiring, and specific switches.
Details Sump Switch and Temperature Pressure Compensation PCB connections.
Covers connections for display backlighting and card readers.
Explains solid state switches and their control of C4000 outputs.
Details terminal functions for single, dual, and quad configurations.
Details terminal functions for MPD6/MPP6 side A and B configurations.
Outlines terminal functions for LPG, CNG, and Bulk Meter applications.
Explains the use of high current triacs and their switch settings.
Explains the function of Power, Watchdog, RXD, and TXD LEDs.
Details output LEDs (triac status) and diagnostic LED states.
Troubleshooting for LED status and power issues.
Steps to resolve motor not starting or running, and solenoid issues.
Steps for troubleshooting display, PIN pad, and printer problems.
Details wiring connections for RS232 communication.
Describes changes for RS485 communication, including board installation.
Details wiring connections for interfacing with Gilbarco equipment.
To Next Page