The following table summarises the parameter switch settings. Information on these settings
and how to change them can be found on the following pages.
NOTE:
The configuration settings must be set before parameter settings can be accessed.
When changing settings on the dispenser, pressing the Parameter switch in quick succession
cycles between the options available. The location of this switch can be found on page 7. Each
press of the button will cycle between the digits. When going through the menus, each menu
will cycle through the digits twice for ease of operation.
When a digit is flashing, hold down the relevant switch to increment this digit. Release the
switch on the desired value.
The system timeout is 10 seconds.
To Next Page
Loading...
Need help?
General
