To Next Page

To Previous Page

12.

K-Factor Settings

Dispenser Settings

The following diagram displays how to change the dispenser settings, such as the meter type,

variant and minimum delivery. To get to the following menu, depress the K-Factor switch once

when not in a transaction. The menu shown is for side A – if side B is required, continue

depressing the K-Factor switch until the same menu for side B is reached and follow the same

set up instructions.

These settings will likely be set in the factory. Only change the following settings if required. See

following pages for information on these settings.

-A

0000000

Meter Settings

1-1 Channel Encoder

2-2 Channel Encoder

3-3 Channel Encoder

4-V50 Meter

Variant Settings

0-Non-LPG

4- AdBlue (Diesel

Emissions Fluid)

5-LPG

Quantity Settings (V50 Meter

Only)

0-Litres Compensated

1-Litres Uncompensated

2-Mass (CNG only)

NOT USED

Minimum Measured

Quantity Exponent –

Must be a valid digit-

see below

Minimum Measured

Quantity Coefficient –

MUST be 1, 2 or 5

Air Settings

0-Normally open – turn

air switch ON for error

1-Normally closed – turn

air switch OFF for error

Compac C5000 User Manual

Other manuals for Compac C5000