Compact Power BOXER 427W

Questions and Answers

N
Natasha MorenoSep 12, 2025
What can cause the machine Compact Power Compact Loader not to travel in either forward or reverse directions?
- R
  Robert Williams PhDSep 12, 2025
  The machine might fail to move forward or backward if: * The engine is not running at full speed. Advance the throttle to full engine speed. * The hydraulic fluid is cold. Fully warm the hydraulic fluid. * The hydraulic fluid level is low. Check and fill the hydraulic fluid tank with the appropriate hydraulic fluid. * The fuel tanks are empty and the engine stops. Fill the fuel tanks with fuel.
T
Thomas YatesSep 14, 2025
What causes a Compact Power BOXER 427W track to “cogging”?
- D
  diazdennisSep 14, 2025
  A Compact Power Compact Loader track may “cog” due to: * Travelling in reverse with a heavy load. Slow down travel and reduce the load on the machine. * Track tension spring fully compressed. Stop travel and reverse direction to allow the tension spring to decompress. Check for debris in the track that could cause the track tension spring to fully compress. * Track tension not set properly. Reset track tension.
N
Nicholas DominguezSep 15, 2025
What causes oil leaks from oil seals and gaskets in a Compact Power BOXER 427W Compact Loader?
- G
  Gregory MurphySep 16, 2025
  Oil leaks from the oil seals and gaskets may be caused by restricted exhaust. Clean the spark arrestor.
J
Jody KingSep 18, 2025
What to do if boom drops downward quickly and then stops on Compact Power BOXER 427W?
- W
  wilkinskennethSep 18, 2025
  If the boom drops downward quickly and then stops, it is due to leaking cylinder seals. Replace the cylinder seals to fix this issue.
S
Sharon CollinsNov 19, 2025
Why won't my Compact Power BOXER 427W Compact Loader engine start, starts hard, or fails to keep running?
- J
  Joseph AndrewsNov 19, 2025
  There are several reasons why your Compact Power Compact Loader might not start, start with difficulty, or fail to continue running. These include: * The auxiliary hydraulics lever is not in the neutral position when a hydraulically powered attachment is installed; move the lever to neutral. * The fuel tanks are empty; fill the fuel tanks with gasoline. * The choke is not on; pull the choke control fully outwards. * The air cleaner is dirty; clean the air filter housing and replace the filter elements. * The spark plug wires are loose or disconnected; install the wires on the spark plugs. If the spark plug wires do not stay connected, contact an Authorized Service Dealer. * The spark plugs are pitted, fouled, or the gap is incorrect; install new, correctly gapped spark plugs. ...
T
Tina McdowellNov 21, 2025
What to do if Compact Power Compact Loader starter does not turn the engine over?
- G
  Gary BassNov 21, 2025
  If the starter on your Compact Power Compact Loader isn't turning the engine over, it could be due to several reasons: * The auxiliary hydraulics lever is in either the Forward or Reverse position without a hydraulically powered attachment installed. Move the lever to the neutral position. * The battery is dead. Charge the battery, or if it won't hold a charge, replace it. * The electrical connections are corroded or loose. Check the electrical connections for good contact. Remove the cables from the battery terminals and fully clean the battery terminals and cable clamps. If the cable clamps cannot be properly cleaned, replace the connectors. * The engine is in a hydraulic lock due to a cylinder filled with fuel. Make sure that the spark plug cables have been moved away from the ...