EasyManua.ls Logo

Compal Electronics NTV00 - 1.1.1 Built-in Camera; 1.1.2 Logo PC Sheet; 1.1.3 Power Key; 1.1.4 TP Lock

Default Icon
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter1 Introducing Your Notebook
- 16 -
1.1.1 Built-in Camera
The built-in camera supports a 1.3 mega pixel web camera.
1.1.2 Logo PC Sheet
The location of Logo badge.
1.1.3 Power Key
Power Buttons
The activity of the power button is as follows:
If system is Off/Hibernate: System will be turned on while Power switch is
depressed.
If system is in Standby state: System will resume while Power switch is
depressed.
If system on with legacy mode: depress this button will turn off power.
If system is running in ACPI OS, the power button acts as the sleep button,
and let OS controls the policy of power button which is defined in Power
Option under the OS.
Power Button Over-ride
Holding down the Power Button for 4 seconds will cause an unconditional transfer to the off
state without notifying the operating system.
1.1.4 TP Lock
To let you disable your touchpad to prevent input errors when typing on your laptop, you
may press “Fn+Esc” to toggle the touchpad on and off.
LED on while “touchpad disable”
LED off while “touchpad enabled”
1.1.5 MIC Phone
Built in internal microphone
1.1.6 Device Status Indicators / Power Status
The LEDs on the front of netbook indicate the device and power status.