NTV00 user’s manual
- 41 -
4.1.2.3 Security Menu
Phoenix SecureCore(tm) Setup Utility
Main Advanced Security Boot Exit
Item specific Help
Supervisor Password Is: Clear
Set Supervisor Password: [Enter]
F1 Help ↑↓ select item F5/F6 change values F9 Setup defaults
Esc Exit ←→ select menu Enter Select 4 Sub-Menu F10 Save and Exit
Set Supervisor Password
Enter this field always shows the message.
While this field is highlighted, then press “Enter” the following message is shown:
Set Supervisor Password
Enter New Password [ ]
Confirm New Password [ ]
If there is an old password then setup will prompt with the following window instead and a current
password will be required to be entered at first:
Set Supervisor Password
Enter current password [ ]
Enter New Password [ ]
Confirm New Password [ ]
User can type password in field of enter new password”, and re-enter password in field of
“confirm new password “ for verification.
If verification OK:
To Next Page
Loading...