Compal Electronics NTV00 - Exit Saving Changes; Exit Discarding Changes; Load Setup Defaults; Discard Changes

Chapter4 The BIOS Setup Program
- 44 -
Save Changes
F1 Help ↑↓ Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select 4 Sub-Menu F10 Save and Exit
Exit Saving Changes
Allows the user to save changes to CMOS and reboot system. The following message is prompted when
user press “Enter” on the item.
Setup Confirmation
Save configuration changes and exit now?
[Yes] [No]
Yes: Exit SETUP and reboot
No: Back to previous screen
Exit Discarding Changes
Setup Warning
Configuration has not been saved!
Save before exiting?
[Yes] [No]
Load Setup Defaults
Allows the user loads default value in CMOS Setup. The following message is prompted when user
press “Enter” on this item:
Setup Confirmation
Load default confirmation now?
[Yes] [No]
It still stay in Setup when press a key.
Discard Changes
Allows the user loads previous value in CMOS Setup. The following message is prompted when press
“Enter” on this item:
Setup Confirmation
Load previous configuration now?
[Yes] [No]