Before removing an SD/MMC/MS card, stop it running from the configuration
utility on the taskbar. Failure to do so could result in the data loss.
3.1.1 Installing a SD/MMC/MS Card
SD/MMC/MS card, with hot-plug feature, allow you to install and remove cards when your
notebook is running. The card will be detected automatically after being installed.
Usually SD/MMC/MS Cards have a mark or symbol to show which end to insert into the
slot. Insert the card according to the orientation symbol, and slide the card into the slot.
Check the documents that came with your card if the orientation is unclear.
Hold the SD/MMC/MS card with its orientation symbol pointing into the slot and the
topside of the card facing up.
Slide the card into the slot until it clicks into the connector.
If you encounter too much resistance, do not force the card. Check the card orientation
and try again.
3.1.2 Remove a SD/MMC/MS Card
To remove the SD/MMC/MS card, please push it in gently and then it ejects automatically.
To Next Page
Loading...
