Compal PBL10 - Page 54

54
You can select the share memory size for UMA use, 32MB/64MB/128MB could be
selected.This select only show on UMA unit
Power On Display
You can select the display device when power on, <Auto-selected>/<System LCD
only> can be selected. When set to “auto-selected”, the SBIOS will detect
attached display device and chose the highest priory device to display. The
display priority is HDMI>CRT>LCD.
If there have HDMI / CRT device connected, the default display mode will as
below.
Internal Graphic : Clone mode (LCD+CRT or LCD+HDMI)
PCIE Graphic : LCD (Depend on Boot Type of setup menu)
* Just discrete unit will show this item. The UMA system will follow the default
setting.
Help information:
NumLock
Selects Power-on state for Numlock.
Peripheral Configuration
Configures the peripheral devices.
Bluetooth/Wlan/Camera/Card Read/Azalia
Enable or Disable this device, and in the submenu [Azalia <Auto>] you also can
select Auto, Enable or Disable.
VT
Virtualization Technology Enable/Disable.
Configure SATA As
Set Hard disk Controller Configure Type.
POST HotKey Delay
Customizable amount of time for the user to press HotKey at POST.
UMA Share Memory Size
Select DVMT5.0 Pre-Allocated(Fixed) Graphics Memory size used by the Internal
Graphics Device.
Power On Display
Select the Video Device that will be activated during POST
USB Legacy
USB devices boot and access in DOS. If disable USB Legacy, USB devices can
not boot
FAST Boot