Compaq 5000 Series - Locating and Removing the DVD-RAM Drive; Identifying the DVD-RAM Drive; Disconnecting Drive Cables

R
EPLACING THE
P
OWER
S
UPPLY
11
4. Disconnect the power supply power cables from the CD 1,
CD-RW 1, and/or DVD drive 1, Diskette drive 2,
Hard drive 3, and System board 4 (see Figure 4-3).
Figure 4-3
Important: The location of the CD, CD-RW, and/or DVD drives may vary
by model.
It is recommended that you
mark the power cable
connectors so that you use the
same connectors when
reattaching them to the system
components. However, you
can actually use any available
connector on the power cable.