10
Setting Up
Use the following procedure to set up the C 120/C 140 before using it for
the first time.
1 Load batteries.
Load the two batteries that come with the C120/CI40 into its main
battery holder.
After loading the main batteries, pull the insulating tape out from
under the back-up battery compartment covet:
2 Wait for about five seconds, and then press the power switch to turn on
power.
3 Adjust the contrast.
• The contrast dial is set to its darkest setting when shipped from the
factory. Rotate the contrast dial until the figures on the screen
become easy to see.
4 Set up the C120/C140.
The welcome wizard appears on the screen after the reset routine is
complete. Perform the following procedures in accordance with the
guidance messages that appear on the screen.
Touch screen calibration
Time and date setting
Personal data input
Other settings
If the welcome wizard does not appear on the screen at this point, first
check to make sure that the main batteries are loaded correctly. Check to
make sure that their positive (+) and (-) ends are facing correctly. After
correcting the problem, use the stylus to press the RESET button.
Press the RESET button causes power to turn off. Press the power switch
to turn it back on, and continue with the above procedure from step 3.
To Next Page
Loading...