Computer Setup—Security
NOTE Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 4 Computer Setup—Security
Option Description
Smart Card Options
(some models)
Allows you to enable/disable the Smart Card to be used in place of the Power-On Password.
Setup Password Allows you to set and enable setup (administrator) password.
NOTE If the setup password is set, it is required to change Computer Setup options, flash
the ROM, and make changes to certain plug and play settings under Windows.
See the Troubleshooting Guide on the Documentation and Diagnostics CD for more information.
Power-On Password Allows you to set and enable power-on password. The power-on password prompt appears after a
power cycle. If the user does not enter the correct power-on password, the unit will not boot.
NOTE This password does not appear on warm boots , such as Ctrl + Alt + Delete or
Restart from Windows, unless enabled in Password Options, below.
See the Troubleshooting Guide on the Documentation and Diagnostics CD for more information.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to:
●
Lock legacy resources (appears if a setup password is set)
●
Enable/disable network server mode (appears if a power-on password is set)
●
Specify whether the password is required for warm boot (Ctrl + Alt + Delete) (appears if a power-
on password is set)
●
Enable/Disable Setup Browse Mode (appears if a setup password is set) (allows viewing, but
not changing, the F10 Setup Options without entering setup password)
See the Desktop Management Guide on the Documentation and Diagnostics CD for more
information.
Embedded Security
(This menu item only
appears after the
Embedded Security
Device is made available
under Device Security.)
Allows you to:
●
Enable/disable the Embedded Security device
●
Reset the device to Factory Settings
●
Enable/disable power-on authentication support. (some models)
●
Reset authentication credential. (some models)
This feature is supported on some models only. See the Desktop Management Guide on the
Documentation and Diagnostics CD for more information.
Device Security Allows you to set Device Available/Device Hidden for
●
Serial ports
●
Parallel port
●
All USB ports
●
Front USB ports
ENWW Computer Setup (F10) Utilities 7
To Next Page
Loading...
Need help?
General
