7
After you enter or establish the strong password, you can select Intel AMT Configuration > Idle
Timeout. ME firmware images that have been field upgraded to AMT 2.1 initially have this value set to
“0x0”, which disables the ME from entering a lower power state during OOB system management. To
enable this function, enter a non-zero value in either HEX or DECIMAL. In the following example, the Idle
Timeout value is set to “0x1”, which configures the ME to transition to a lower power state if AMT is
configured to provide OOB during system sleep states after 1 minute of idle time. All Idle Timeout val-
ues are in minutes. The lowest value of 1 minute offers the most energy savings.
To Next Page
Loading...
