13
Appendix A: POST Error Messages
The following are POST error messages related to VA problems during system boot.
Post Error Message Suggested Action
VA Version
Applicable
2213-EIT Failure Hardware for VA support not
present.
Ensure Intel AMT is enabled and a VT-
capable processor is installed.
2.x
2214-EIT Failure VA partition corrupt or missing. Ensure drive with VA image is installed
correctly.
3.x
2215-EIT Failure VA boot record read failure. Ensure drive with VA image is installed
correctly.
2.x
2221-EIT Failure VA partition corrupt or missing. Enter MEBx setup and change Verified
Boot Policy to continue normal boot.
2.x
2222-EIT Failure Unknown boot policy returned
from MEBx.
Upgrade ME firmware. Re-flash BIOS. 2.x
2223-EIT Failure VT must be enabled to launch VA. Enter F10 Setup and enable Intel Virtu-
alization Technology.
2.x and 3.x
2224-EIT Failure Embedded Security must be avail-
able to launch VA.
Enter F10 Setup and set Embedded
Security Device to Device Available.
2.x
2225-EIT Failure VT-d must be enabled to launch
VA.
Enter F10 Setup and enable Intel Virtu-
alization Technology Directed I/O.
3.x
2226-EIT Failure TXT must be enabled to launch VA. Enter F10 Setup and enable Trusted
Execution Technology.
3.x
2227-EIT Failure Embedded Security must be
enabled to launch VA.
Enter F10 Setup and set Embedded
Security Device support to Enable.
3.x
2228 EIT uninstall has automatically dis-
abled VT.
No action required. For some BIOS
versions, VT is disabled after uninstall-
ing a VA. Virtualization Technology
should be turned off when not in use
for security reasons. This is done to
protect your system from malicious
attacks. To re-enable VT, enter F10
Setup and set Virtualization Technol-
ogy to Enable.
2.x
2229-EIT Failure VA does not support processors
with more than two cores.
Replace processor with a single or
dual core processor.
2.x
To Next Page
Loading...
