USB Legacy Mode
Support
Allows you to set:
●
Disabled
●
Enabled
Onboard LAN Allows you to disable/enable onboard LAN controller.
Onboard LAN Boot
ROM
Allows you to disable/enable the boot ROM of the onboard LAN chip.
SATA1 Controller Allows you to disable/enable the SATA1 Controller.
SATA1 Controller
Mode
If SATA1 Controller is enabled, allows you to set the mode to:
●
IDE
●
AHCI
SATA2 Controller Allows you to disable/enable the SATA2 Controller.
Onboard Audio Allows you to set the onboard audio to:
●
Auto
●
Disabled
●
Enabled
Internal Speaker Allows you to set the internal speaker to:
●
Disabled
●
Enabled
Supervisor Password Allows you to change supervisor password.
User Password Allows you to change the user password.
Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3 Computer Setup—Power
Option Description
After AC Power Failure Allows you to select system restart behavior after power loss:
●
Stay Off
●
Power On
●
Auto
XD Disables/enables XD bit.
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2 Computer Setup—Advanced (continued)
4 Computer Setup (F10) Utility ENWW
To Next Page
Loading...
