Compaq.com - Compaq Presario Maintenance and Service Guide - Series
United States December 10, 2002
Maintenance and Service Guide
Compaq Presario EZ2000 Series Computers
Product Description Troubleshooting
Illustrated Parts
Catalog
Home
Removal &
Replacement
Jumper & Switch
Information
Specifications
Models and
Features
Digital
Dashboard
CPU Controls
and Lights
Right Easy
Access Panel
Left Easy
Access Panel
USB
Keyboard
Controls
Rear CPU
Connectors
Power Cord
Set
Requirements
PRODUCT DESCRIPTION
Power Cord Set Requirements
The power cord set (flexible cord and wall plug) received with the computer
meets the requirements for use in the country where the computer was
purchased.
Power cord sets for use in other countries must meet the requirements of
the country where you use the computer. For more information on power
cord set requirements, contact your Compaq authorized dealer, reseller, or
service provider.
General Requirements
The requirements listed below are applicable to all countries:
1
The length of the power cord set must be at least
6.00 feet (1.8 m) and a maximum of 9.75 feet (3.0
m).
2
All power cord sets must be approved by an
acceptable accredited agency responsible for
evaluation in the country where the power cord set
will be used.
3
The power cord set must have a minimum current
capacity of 10A and a nominal voltage rating of 125
or 250 volts AC, as required by each country's power
system.
4
The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector, for mating with appliance inlet
on the Switch Box.
Country-Specific Requirements
Country Accredited Agency
United States UL*
US/Canada UL and CSA
* The flexible cord must be Type SJT-2 or equivalent, No. 18
AWG, 3-conductor. The wall plug must be a two-pole
grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-
15P (15A, 250V) configuration.
privacy and legal statement
http://h18000.www1.hp.com/athome/support/msgs/2200-2700/pwrcrd.html [12/10/2002 9:25:59 AM]
To Previous Page
Loading...