Compaq Presario 7360 - Preparation for Disassembly

United States December 31, 2002
Maintenance and Service Guide
Compaq Presario 7300 Series Computers
Product Description Troubleshooting Illustrated Parts Catalog
Home Removal & Replacement Jumper & Switch Information Specifications
DISASSEMBLY
SEQUENCE
Electrostatic
Discharge
Service
Considerations
Preparation
for
Disassembly
Serial Number
Chassis Cover
Fax-Modem
Mass Storage
Devices
System Board
and
Components
Power Supply
REMOVAL & REPLACEMENT
Preparation for Disassembly
To prepare the computer for removal and replacement procedures, complete the following steps:
1
Remove any diskette, compact disc, or tape from the computer.
2
Turn off the computer and any peripheral devices that are connected to the
computer.
CAUTION: The computer power switch should
be turned off before you disconnect any cables.
3
Disconnect the power cord from the electrical outlet, and then from the
computer.
4
Disconnect all peripheral device cables from the computer.
IMPORTANT: During disassembly, label each cable as you remove
it. Be sure to note its position and routing.
privacy and legal statement