Microphone module
Description Spare part number
Microphone module and cable 517629-001
Before removing the microphone module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 34).
5. Remove the following components:
a. Optical drive (see
Optical drive on page 35)
b. Keyboard (see
Keyboard on page 44)
c. Keyboard cover (see
Keyboard cover on page 46)
d. Speaker assembly (see
Speaker assembly on page 49)
e. Display assembly (see
Display assembly on page 51)
Remove the microphone module:
1. Release the tabs (1) built into the display enclosure.
2. Release the microphone receiver (2) from the display enclosure. The microphone receiver is
secured by two-sided tape.
3. Remove the microphone cable (3) and receiver from the display enclosure.
Reverse this procedure to install the microphone module.
58 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
