5–46 Maintenance and Service Guide
Removal and Replacement Procedures
2. Remove the two Phillips PM1.5×3.0 screws 1 that secure the
Bluetooth module to the top cover.
3. Slide the Bluetooth module 2 out of the clip in the top cover.
4. Disconnect the Bluetooth module cable 3 from the Bluetooth
module.
5. Disconnect the Bluetooth module cable 4 from the system
board.
✎
The Bluetooth module cable is included with the Bluetooth
module and is also available in the Cable Kit, spare part
number 407774-001.
Removing the Bluetooth Module
Reverse the above procedure to install the Bluetooth module.
To Next Page
Loading...
