99
SI/SO Control
RIS ENABLE YES
↑
SI/SO CTL YES
→ or ←
SI/SO CTL NO
→ or ←
↓
AUTO CR YES
If the printer receives a command (SI or SO) from the host to enable or disable the special
modes (oversize, expanded and bar code modes), then the printer will (YES) or will not (NO)
respond to the <SI> and <SO> commands based upon your selection.
Auto Carriage Return
SI/SO CTL YES
↑
AUTO CR YES
→ or ←
AUTO CR NO
→ or ←
↓
PRIME ON DEL YES
If the printer receives a command (LF) from the host to perform a line feed then the printer
will (YES) or will not (NO) append a carriage return based upon your selection.
To Next Page
