100
Prime on Delete
AUTO CR YES
↑
PRIME ON DEL YES
→ or ←
PRIME ON DEL NO
→ or ←
↓
CONTRL IN DG YES
If the printer receives a command (DEL) from the host, then the printer will (YES) or will not
(NO) perform a prime (reset) based upon your selection.
Control Codes in Dot Graphics
PRIME ON DEL YES
↑
CONTRL IN DG YES
→ or ←
CONTRL IN DG NO
→ or ←
↓
CONTRL IN DG YES
If the printer receives a control code from the host while in dot graphics mode, then the
printer will (YES) or will not (NO) respond to the particular control code based upon your
selection.
To Next Page
Loading...
