6
• To install the thermostat, detach the rear panel of the thermostat
from the front panel by pressing the lock on the upper side of
the housing of the thermostat, as shown in the gure.
• With the help of the screws provided and some tools fasten
the rear panel of the device to the wall.
• Using a small screwdriver, remove the cover of
the terminal block from the inner side of the rear
panel. The thermostat controls the boiler or air
conditioner through a potential-free alternating
relay that has the following connection points:
1 (NO); 2 (COM) and 3 (NC). These connection
points are located under an inner cover on the
inner side of the rear panel.
• Connect the two connection points of the heating
or cooling equipment to be controlled to the
normally open 1 (NO) and 2 (COM) terminals of the relay. If you
To Next Page
Loading...
