plugs and/or changing the position of the orange-colored
potentiometer) located on the main panel.
3.1 Selecting the Displayed Temperature
The temperature(s) to be shown on the display can be
selected and set by the left jumper.
With factory default settings the jumper is located on the cent-
ral and uppermost pins, in which case the display shows the
currently measured room temperature value, while the notice
“ROOM” appears in the bottom right corner of the display. In
this case, the adjusted temperature is visible only during the
adjustment process, for approximately 6 seconds after the last
button has been pushed.
By relocating the plug onto the bottommost and central pins
the displayed temperature can be modied so that the display
alternately shows the current room temperature and the adjus-
ted temperature for 3-3 seconds, respectively. In this mode,
the notices “ROOM” and “SET” are alternately shown under
the currently displayed temperature in the bottom right corner
- 9 -
To Next Page
Loading...
