Computherm Q7RF - Page 11

- 11 -
becomes visible continuously while the numbers indicating
the hour will flash on the display. Using the large and
buttons on the front panel of the device, set the hour
value of the current time. Press the “DAY ” button again. At
this time the numbers that indicate the hour stop flashing and
become visible continuously, while the numbers indicating the
minute will begin flashing. Using the large and
buttons on the front panel of the device, set the minute value
of the current time.
When you wish to continue modifying the settings, please
press the “DAY” button again. If you wish to finish settings,
confirm them by pressing the “SET” button. At this point
adjusted data are recorded and the device goes back to the
main screen (if no buttons are pressed for at least 15 seconds,
the settings are automatically confirmed and the device goes
back to the main screen).
2.3 Switching between the heating and cooling mode
There is a possibility to easily switch between the heating
and cooling mode of the thermostat. The output terminals