- 10 -
After the batteries have been inserted, the display flashes
the day, time and program number as well as the adjusted
and measured temperatures. (If this information fails to
appear on the display, press the “RESET” button located on
the main panel of the thermostat. After the batteries have
been inserted, snap the front panel of the device into the rear
panel and press the “SET” button. After the “SET” button is
pressed, the display stops flashing, the thermostat goes to
the main screen and the setting process can be started.
2.2 Setting the current day and time
Press the “SET” button to go to the main screen, then press
the “DAY ” button. At this time only the first three letters of
the current day of the day will flash on the display of the
thermostat and the hour and minute values can be seen.
Using the large and buttons on the front panel of
the device, set the current day (Monday MON; Tuesday TUE;
Wednesday WED, etc.). Press the “DAY” button again. At this
time the abbreviation indicating the day stops flashing and
To Next Page
Loading...
