- 20 -
buttons. The conrmation of a value is always
done by pressing the “PROG” button, after which the
next value can be adjusted. The program can be saved
by pressing the “SET” button. A more detailed description
of the programming steps can be found in Chapter 4.3.
• If there are days, for which the same program is needed,
than it is sucient to create that program only once, since
it can be easily copied to another day using the “COPY”
button as described in Chapter 4.4.
If the same program is needed for every day, then there
is also a possibility to create the program of all the days
together (by selecting MON TUE WED THU FRI SAT
SUN together during the selection of days). But be aware:
if the program of all the days are created together, than
their program can only be modied together. Therefore,
if a dierent program is needed for at least one day,
then the program of the days should be created separately,
and the repeated programs should be copied using the
“COPY” button.
• A separate program can be created for the heating and
To Next Page
Loading...
