7
2d bar code. Provides the same information as sticker
number three, but a 2d laser scanner is needed to
decode the information.
1d bar code. Place this sticker on or around the CompX
eLock® unit to help identify which codes to use if
resetting the lock is necessary.
Keep this sticker in a safe location.
Serial #: Needed to identify CompX eLock® units
Passcode: Unique to lock. Needed for LockView.
Prevents unauthorized LockView use
User Rst: Allows administrator or owner to erase
all user codes from eLock unit but keep
supervisor codes
Fact Rst: Erases all codes from eLock, including
settings. eLock unit will need to be set
up again after a Factory Reset
Sticker #1
Sticker #2
Sticker #3
CompX eLock
®
Warranty Card
These stickers are included with each CompX eLock® unit. Please review the information and keep the stickers in a
safe location as they may be needed to reset or identify a specific eLock unit. The codes shown here are not real codes.
They are representations of what the stickers will look like.
To Next Page
Loading...
