COMPX elock User Manual

2
CompX eLock Instructions continued
Unit Features:
w Choose 802.11g or Ethernet Networked configurations that
uses the facilities existing infrastructure for actual 2-way
read/write communication
w Each eLock can hold any combination of up to 3,000
Supervisors and Users
w Choose a model to use existing HID Prox, HID iCLASS, or 3
track magstripe card credentials that can be programmed to
operate each eLock
w View, print and download a 15,000 event access audit trail
via the LockView Software (see LockView Instruction Manual
for complete audit trail details)
w View, print and download a 500,000 event temperature
audit via the LockView Software (temp monitoring required)
(see LockView Instruction Manual for complete audit trail
details)
w Standard Temperature Monitoring eLock
-40ºC to 100ºC (-40º F to 212º F)
w Ultra Low Temperature Monitoring eLock
-100º C to -40º C (-148º F to -40º F)
w Accuracy within +/- 0.5º C (temp monitoring required)
w NIST certification available (temp monitoring required)
w Interactive 128 x 64 dot matrix LCD with blue backlight that
adjusts to 3 different angles for easy viewing
w Remote Notification System with programmable escalating
alerts via SMTP email; SMS text, voice and fax (Networked
eLock & LockView Software required)
w Spring bolt latching mechanism provides automatic
relocking
w Optional second latch drive output (requires additional
hardware)
w Door position switch input (requires additional hardware)
w Membrane keypads with stainless steel domes provides
durable performance and easy cleaning
w Detachable mounting plate simplifies installation
w Choose from 3 different mounting configurations (vertical,
horizontal right hinge, horizontal left hinge) that will fit most
refrigerators, freezers, and incubators
What’s in the box?
w 1 -- eLock
w 1 -- eLock mounting plate
w 1 -- strike (8” for standard or 14” for ultra low)
w 1 -- strike plate cover
w 8 -- #8 x 3/8” pin-in Torx flat head mounting plate sheet
metal screw
w 2 -- #8 x 1/2” pin-in Torx pan head strike plate sheet metal
screw
w 2 -- #8 x 1/2” pin-in Torx flat head strike plate cover machine
screw
w 2 -- 7 1/2” x 1” strike plate foam tape
w 2 -- 5 1/2” x 1” mounting plate foam tape
w 1 -- 4 1/2” x 1” mounting plate foam tape
w 4 -- adhesive backed temperature cable mounting clip
(temperature monitoring only)
w 1 -- adhesive backed temperature probe mounting clip
(temperature monitoring only)
w 1 -- battery cover that includes knock-out for Ethernet (if
equipped) and AC power adapter (not included)
w 1 -- warranty card
w 1 -- serial code sticker set
w 1 -- in-box instructions
What’s needed?
w T15 pin-in Torx (6-lobe) bit or driver
w 6 AA alkaline batteries
w ruler or tape measure
w drill (if screws will be uses as the method of attachment)
w pencil
Care and Cleaning
The eLock is a battery operated device, therefore, it should
be part of a regular battery maintenance program.
To clean the surface of the eLock, apply non-acid based
cleaner to a clean cotton cloth; do not spray cleaner directly
on the eLock. Wipe down keypad and housing taking care
around the beeper opening and edges of keypads. Wipe
excess cleaner off of all surfaces.

COMPX elock Specifications

General

Brand	COMPX
Model	elock
Category	Locks
Language	English